House of Fara OCOE8 Installationsanleitung PDF herunterladen

How to Install Base Moulding & Blocks

To install base moulding and blocks you will need a power drill and a 3/32-inch drill bit, hammer and 2-inch finishing

nails, a hand and/or power saw, putty or wood filler, counter sinker, measuring tape, pencil and safety glasses.

(A) If possible install base moulding first when trimming a room with Fara moulding. After the base is installed, you

will have a convenient starting place when you trim the doorways.

(B) Paint or stain the moulding and blocks before installing them. This will save time and ensure a “professional”

looking job.

First drill three 3/32” holes in the outside corner block.

(D) Position block on corner of wall (see #1 in illustration at top of page). The groove in the back of the block

automatically positions it correctly on the wall. Nail in place with 2” finish nails.

1 2 3

Seite 1

How to Install Base Moulding & Blocks To install base moulding and blocks you will need a power drill and a 3/32-inch drill bit, hammer and 2-inch

Seite 2

(E)Place inside corner block tightly in corner (see #3 in illustration at top of page). Measure the distance from the outside corner to the inside co

Seite 3

(J) Measure distance between inside corner block (#3) and pencil line. (K) Cut base moulding to this length using straight cuts. Drill holes in bas

Keine Kommentare

House of Fara OCOE8 Installationsanleitung